Browse all practice questions for the NEIEP Electrical Theory and Application (430) Practice Exam. Search by topic, open any question and review its full explanation, then test yourself in the practice quiz.

NEIEP Electrical Theory and Application (430) Practice Exam course image
More practice questions

These questions are part of the practice quiz. Start practicing

  • For resonance in a series RLC circuit, which condition is true?
  • An ideal transformer has turns ratio a = N_p/N_s. Which expression correctly gives the impedance seen at the primary when the secondary is loaded with Z_L?
  • In capacitor-start induction-run motors, at approximately what percent of rated speed is the start winding disconnected by the centrifugal switch?
  • Which expression defines real power P in an AC circuit?
  • In a squirrel cage rotor, the bars or rods are oriented parallel to the axis of rotation.
  • Which formula does a wattmeter use to measure real power in AC circuits?
  • Which expression correctly describes the reflected impedance on the primary of an ideal transformer with turns ratio a?
  • Kirchhoff's Voltage Law (KVL) and Kirchhoff's Current Law (KCL) describe which of the following statements?
  • Which of the following expresses the total three-phase real power for a balanced system?
  • What is the effect of inserting a capacitor in series with a signal to create a high-pass filter?
  • How does frequency affect the reactance of an inductor and a capacitor respectively?
  • What is the purpose of a voltage divider in a two-resistor circuit?
  • In the parallel circuit across 12 V with 6 Ω and 3 Ω resistors, what is the current through the 3 Ω resistor?
  • In a series circuit containing a resistor, inductor, and capacitor at resonance, what happens to the reactive part of the impedance?
  • Which of the following statements is correct regarding an AC induction motor?
  • How does a rotating magnetic field work in an AC motor?
  • Which statement is true about the rotor of a permanent magnet motor compared to the stator's field?
  • For a universal motor, current flows in the [same/different] direction through the armature and field winding?
  • Which statement about a 12-lead motor is true?
  • Why is a squirrel‑cage rotor commonly called a cage rotor?
  • A 4-pole, 60 Hz motor has synchronous speed of?
  • How is a 9-lead motor connected for low voltage (example 230 V)?
  • Which statement properly describes RMS values and their use in power calculations?
  • A 12 V DC source powers a 4 Ω resistor. What is the current and power dissipated?
  • In a balanced three-phase system, what is the expression for the total apparent power S using line voltage and line current?
  • Which expression gives the total reactive power for a balanced three-phase system using line voltage and current?
  • Which symbol represents a 3-phase motor on a schematic?
  • AC motors that use stators are called?
  • What is the rotating speed of a three-phase 30 Hz 6-pole motor?
  • Does the rotor of a synchronous motor rotate at synchronous speed?
  • What is the definition of phase loss (single-phasing)?
  • A change from ABC phase sequence to ACB phase sequence will cause the motor to:
  • Which statement correctly distinguishes capacitor-start induction-run motors from capacitor-run motors?
  • What is the rotational speed of the stator's magnetic field called?
  • What does the light bulb test help identify?
  • Which of the following statements applies to universal motors?
  • How does a transformer reflect impedance and why is it important for design?
  • How does a multimeter measure current and what precautions are needed?
  • Which statement correctly describes a capacitor-run (permanent split capacitor) motor?
  • Why does swapping two leads reverse the motor?
  • What is the expression for apparent power S in terms of real power P and reactive power Q?
  • What is slip in an induction motor?
  • What defines a permanent magnet AC motor (PMAC) rotor?
  • What is the synchronous speed of a 12‑pole, 60 Hz motor?
  • What is the synchronous speed of a 3-phase, 6-pole motor at 25 Hz?
  • What is a 12-lead AC motor?
  • In a series resonant circuit, increasing the Q factor has what effect on the bandwidth?
  • Which statement describes a dual-capacitor (capacitor-start capacitor-run) motor?
  • In a series circuit with resistors 2 Ω, 5 Ω, and 7 Ω, what is the total resistance?
  • What is a phasor diagram and how does it help analyze AC circuits with complex impedance?
  • Maintenance characteristics: AC motors vs DC motors.
  • What do unbalanced resistance readings indicate?
  • If the voltage across a capacitor doubles, by what factor does the stored energy change?
  • Which of the following best describes the split-phase motor?
  • In a series RLC circuit at resonance, which statement is true?
  • What is a 3-lead AC motor?
  • What is the formula for synchronous speed?
  • Increasing capacitance in a capacitor bank connected to a lagging inductive load primarily:
  • Which statement accurately describes a main difference between AC and DC motors?
  • What is a key difference between 9-lead and 12-lead motors in terms of configurability?
  • Define impedance Z and its relation to resistance and reactance in AC circuits.
  • If R = 8 Ω and X = 6 Ω, what is the magnitude of the impedance |Z|?
  • For resistors of 4 Ω, 6 Ω, and 12 Ω connected in parallel to a 120 V source, what is the total current?
  • Which statement is true about synchronous speed?
  • If phase sequence is ABC (counterclockwise), what is the rotation for sequence BAC?
  • In AC circuit power calculations, what does cosφ represent?
  • To increase starting torque in a split-phase motor, what is added in series with the start winding?
  • How is impedance reflected from secondary to primary in an ideal transformer with turns ratio a = Np/Ns?
  • Which of the following is not a form of Ohm's Law?
  • Which of the following is a motor that can be run on both AC and DC?
  • For maximum power transfer in AC circuits, the load impedance should be the complex conjugate of the source impedance. Which equation expresses this?
  • For a three‑phase 60 Hz motor with 6 poles rotating at 1157 rpm, what is the percent slip?
  • Which expression correctly represents Vout in a simple two-resistor voltage divider with Vin across R1 and R2 in series and Vout across R2?
  • Which statement about synchronous speed concept is true?
  • What is the energy stored in an inductor and a capacitor, respectively?
  • Power factor is defined as cos φ, the angle between voltage and current?
  • In a high-pass filter formed by a capacitor in series with a signal, which frequency components are attenuated?
  • In AC circuit design, what is meant by conjugate matching for maximum power transfer?
  • What is a 9-lead AC motor?
  • In a parallel circuit with two resistors 6 Ω and 3 Ω connected to a 12 V source, what is the equivalent resistance?
  • What is the Thevenin equivalent used for circuit analysis?
  • What is the unit of conductance G?
  • In a damped parallel LC circuit at resonance, the impedance is:
  • What is the purpose of a protective device in a circuit and name two common types?
  • What is a 6-lead AC motor?
  • Thevenin's theorem allows you to replace a network with what two elements?
  • What is the synchronous speed of a 60 Hz motor with 8 poles?
  • When checking windings, why should resistance readings from each terminal to ground be infinite?
  • What is the rotor speed for a 4‑pole, 60 Hz squirrel‑cage motor with a slip of 3.76%?
  • In a Wye connection, how are the coils arranged?
  • A true statement about split-phase motors is that the start winding is used only during acceleration.
  • The stator's delta winding has a common connection between phases.
  • In a split-phase motor, which winding is removed before reaching full speed?
  • If a motor has a service factor of 1.15 and is rated at 10 HP, what is the maximum continuous horsepower it can deliver under proper conditions?
  • The rotor of a permanent magnet motor turns at the same speed as the stator's magnetic field.
  • In an unmarked 9-lead motor, which leads are the two ends of the same coil?
  • What is the maximum power transfer condition in a DC circuit with a Thevenin source?
  • In a typical induction motor, rotor speed is less than the synchronous speed due to slip.
  • Which NEMA design letter corresponds to high starting torque?
  • What is the ideal transformer turns-ratio equation relating primary and secondary voltages?
  • Speed control methods.
  • What is the general expression for three-phase real power that is valid for both wye and delta configurations?
  • What is capacitive reactance XC and how does it depend on frequency?
  • The difference between synchronous speed and the rotor speed is called what?
  • How are motor windings shown on connection diagrams?
  • Which acronym does RMS stand for?
  • What is the impedance of a parallel LC circuit at resonance (assuming ideal components)?
  • How do you reverse a 3-phase induction motor?
  • If slip is zero, the rotor speed is equal to which speed?
  • What is the synchronous speed of a 3-phase, 60 Hz, 6-pole motor?
  • In a squirrel‑cage induction motor, the rotor is composed of which of the following?
  • In an ideal transformer with turns ratio Np:Ns = 2:1, which statement is correct?
  • What is the percent slip for a 6-pole, 60 Hz motor with a nameplate speed of 1170 RPM?
  • Why is power factor correction achieved by adding a capacitor in parallel with inductive loads?
  • What is a phasor and why is it used in AC circuit analysis?
  • Which expression correctly gives energy delivered to a resistor with constant voltage V across it for time t?
  • What is a universal motor?
  • What is synchronous speed?
  • If the phase sequence of a three‑phase induction motor is changed so that the opposite direction is produced, what is the most likely outcome?
  • A transformer has a turns ratio of 2:1 (step-down). If the primary is 480 V, what is the secondary voltage ignoring losses?
  • How is a 12-lead motor connected for low voltage wye (example 230 V)?
  • What device is typically required to operate a PMAC motor?
  • Slip is defined as the percentage difference between which two speeds?
  • In a series RLC circuit, which parameter primarily determines the bandwidth around resonance, and which standard expression defines Q for a series circuit?
  • Leads on motor connection diagrams are numbered according to standard as what?
  • In a purely resistive AC circuit, what is the phase angle between voltage and current?
  • What are the two main parts of an AC induction motor?
  • In a phasor diagram, which quantities are represented as vectors to show their relationship?
  • A 6-pole, 60 Hz motor runs at 1,140 RPM. What is its percent slip?
  • What is the motor term for a device designed to run on both AC and DC?
  • In a balanced wye-connected three-phase system, what is the relationship between line-to-line voltage and line-to-neutral voltage?
  • The Code Letter on a motor nameplate is used for what purpose?
  • Calculate synchronous speed for a 4-pole motor on 60 Hz.
  • How do you calculate the energy stored in a capacitor when the voltage across it is V?
  • How do you calculate the magnitude of impedance |Z| from R and X?
  • During phase loss, which of the following is a typical consequence?
  • Which item is typically shown on an AC motor nameplate to indicate how much overload the motor can handle continuously?
  • How would you determine the voltage across a resistor in a voltage divider with R1=2kΩ and R2=3kΩ across a 12 V source?
  • How is a 9-lead motor connected for high voltage (example 460 V)?
  • In AC power calculations, what does the angle φ represent?
  • How is a 12-lead motor connected for high voltage wye (example 460 V)?
  • With a turns ratio a = 0.5 in an ideal transformer, which expression gives the reflected impedance on the primary?
  • Performance differences.
  • In a split-phase motor, the start winding is disconnected before reaching full speed.
  • What is the purpose of tying the neutral leads together in a wye configuration?
  • Why can't a 9-lead motor be reconfigured from wye to delta?
  • In a squirrel cage rotor, the heavy conducting elements running parallel to the axis are called?
  • In a 9-lead motor, which lead is connected to the tap on the T1-T4 coil?
  • How can you detect phase loss electrically at the motor terminals?
  • In an AC circuit with sinusoidal voltage and current, how does instantaneous power p(t) differ from average power?
  • In a balanced three-phase system, which formula gives the real power P using line voltage, line current, and power factor?
  • Which statement best describes a capacitor-start induction-run motor?
  • What design feature helps reduce slot ripple in a squirrel cage rotor?
  • Which expression defines the net reactance X in a circuit containing inductive and capacitive elements?
  • What is the power factor in relation to the phase angle φ in an AC circuit?
  • How do you compute the RMS value of a sine-wave voltage from its peak value?
  • The stator's wye windings have a common connection between phases called the
  • If the power factor is 0.8 leading, what does this indicate about the circuit?
  • In a single-phase circuit, reactive power is Q = V I sinφ. What does a positive Q indicate about the load?
  • Which is an advantage of PMAC motors?
  • Susceptance in AC circuits is defined as -1/X and has units of Siemens. Which statement is correct?
  • What provides the rotating magnetic field in an AC induction motor?
  • On a motor nameplate, the "Frame" designation indicates what?
  • What is the synchronous speed for a 2‑pole, 60 Hz motor?
  • Synchronous speed is defined as the rotational speed of which component in an induction motor?
  • What is the typical slip percentage for a standard induction motor?
  • If a 60 Hz, 4‑pole motor operates with a slip of 3%, what is the rotor speed?
  • Which motor type uses permanent magnets on the rotor?
  • In a squirrel‑cage rotor, the end connections that short the rotor bars are called:
  • On a motor nameplate, what does HP stand for?
  • Which statement best describes a typical high-voltage connection for a 9-lead motor?
  • In a Delta connection, three coils are connected in what shape?
  • What is inductive reactance XL and how does it depend on frequency?
Subscribe

Get the latest from Passetra

You can unsubscribe at any time. Read our privacy policy